Bosch MAP Control Center IUI-MAP0001-2 User Manual page 22

22 en | Operation
–
Figure 2.21 Enter Smartkey Token Number keypad screen
–
Notice!
If no Smartkey profiles are programmed, the message Attention - Use RPS to Add Smartkey
Configuration (Figure 2.22 Attention – Use RPS to Add Smartkey Configuration, page 23)
appears.
2014.11 | 06 | F.01U.168.328
If you wish to enter the Smartkey token's ID number at the control center, press Enter
Smartkey Token Number. The Enter Smartkey Token Number keypad screen (Figure
2.21 Enter Smartkey Token Number keypad screen, page 22) opens. Refer to Table 2.3
Arming indicators, page 15 for information about using the commands at the bottom of
the screen.
– Use the on-screen keypad to enter the 8-character ID found on the Smartkey token.
The code appears in the Enter field and a Verify Code field appears.
– Enter the same code again. The code appears in the Verify Code field.
– Press OK.
If the token number in the Enter field matches the number entered in the Verify
Code field, the Smartkey token number appears in lighter text under the Enter
Smartkey Token Number button name on the Add Smartkey User screen. If these
numbers do not match, an error message is displayed, and you must re-enter the
token number and verify code.
On the Add Smartkey User screen (Figure 2.20 Add Smartkey User screen, page 21), press
Select Smartkey Profile. The Select Smartkey Profile screen (Figure 2.23 Select Smartkey
Profile screen, page 23) opens.
User Manual
MAP Control Center
Bosch Sicherheitssysteme, GmbH