Commissioning On The Devicenet; General Information - Festo CDVI-DN Series Electronic Manual

Valve terminal

Table of Contents

2. Commissioning

2.2

Commissioning on the DeviceNet

2−6

Please note

The Festo valve terminal type CDVI−DN can be used on

all DeviceNet masters.

This chapter describes configuration and commissioning

using the example of the Allen−Bradley controlllers.

If the CDVI valve terminal is used on the DeviceNet, the

following special features must be observed:

The I/O addresses of all recognized DeviceNet slaves can

be assigned freely as M−file addresses or as discrete I/Os

in the Scanlist.

The address assignment of a network slave is usually

carried out in ascending sequence.

The input and output addresses can be assigned indepen

dently of each other.

Please note

Assign the I/O addresses of the network slaves so that

there is sufficient reserve for later extensions.

The following sections contain general valid instructions on

configuring a valve terminal on the DeviceNet.

Detailed information can be found in the documentation or

the Help for the configuration program you are using.

Festo P.BE−CDVI−DN−EN en 0404NH

Table of Contents