Extending The Cdvi - Festo CDVI-DN Series Electronic Manual

1. Installation
1.5

Extending the CDVI

Festo P.BE−CDVI−DN−EN en 0404NH
You can connect further CP modules to the CDVI−DN via the
CP extension connection.
Fig. 1/10: CP extension connection
Please note
Modules, which you connect to the CP extension connec
tion, will only be recognized if the DIL switches are set
correctly.
Information on setting the DIL switches can be found in
section 1.2.2.
You can connect the following CP modules to the CP exten
sion connection:
CP input module with 8 or 16 inputs, either with M12
plugs (sockets assigned twice) or M8 plugs (sockets
assigned once).
CP input module (IP20) with 16 inputs.
CP output module with 8 outputs Power supply for the
electronics via the CP extension connection. Load voltage:
separately via an M18 plug.
CP output module with 4 outputs Power supply for the
electronics and load via the CP string.
CPV valve terminals in sizes 10, 14 and 18 mm. These are
available with 4, 6 or 8 valve plates.
CP
1−27