Activating Iorsf - Fujitsu BS2000 SE Series Operating Manual

Examples of SVP operation

4.5.2 Activating IORSF

The set IORSF must be activated with an IMPL:
Requirement
You are in the AUXILIARY FRAME: IORSF CONTROL.
Click on [RETURN] to switch back to the AUXILIARY FRAME: MENU.
Ê
Enter
Ê
The AUXILIARY FRAME: POWER STAND-BY/IMPL screen is displayed:
RA
Figure 28: AUXILIARY FRAME: POWER STAND-BY/IMPL screen
Enter
Ê
The following prompt appears on the screen:
***********************************
*
* ARE YOU SURE ? (ENTER Y OR N) N *
*
***********************************
v
Press the [Y] key to execute the IMPL or the [Y] key to cancel the procedure. Confirm
Ê
your entry with the [ENTER] key.
58
in the SELECTION=> field. Press the [ENTER] key.
4
----- AUXILIARY FRAME: POWER STAND-BY/IMPL ----- E90L01G
FUNCTION=>
CL-0
in the FUNCTION=> field to execute an IMPL. Press the [ENTER] key.
2
CAUTION!
The IMPL must not be executed during system operation! If this instruction is
not heeded, BS2000 will be aborted!
2
*1 POWER STAND-BY
*2 IMPL
CPU-0 CHP-0
*
*
Operating the service processor
RUN
[]-[]00
U41859-J-Z126-2-76