Fujitsu BS2000 SE Series Operating Manual page 13

Operating the service processor
A new window opens in which a terminal emulation sets up the connection to the SVP
console:
Confirm connection setup with the [ENTER] key.
Ê
After a brief wait time, the SVP frame below is displayed:
After the server has been started: the MODE SELECTION FRAME (see
●
After the SVP console has been closed and opened again or when an SVP console has
●
already been opened by another user: the last frame displayed.
v
U41859-J-Z126-2-76
CAUTION!
When the SVP frame is opened again or when another SVP console is opened by
another user, the window content is not displayed in full.
Click on . This causes the screen to be refreshed, i.e. the frame that was last
[Clear]
output is displayed again in its entirety.
If possible, the SVP should only be used via an SVP console. As frame outputs are
sent to all active SVP consoles, operating multiple SVP consoles at the same time
leads to them impairing each other.
Opening the SVP console
page 24)
13