Ma) Manual Operation Frame - Fujitsu BS2000 SE Series Operating Manual

Operating the service processor

4.4.4 (MA) MANUAL OPERATION FRAME

Figure 11: MANUAL OPERATION FRAME screen
By making an entry in this frame and pressing the [ENTER] key, you can perform various
manual operations.
Instructions on this frame are only executed when the CPU has been stopped (see
message in frame line 23). The CPU status is displayed in line 22.
Selection of a CPU by clicking on [PF16]
Ê
Stopping of the selected CPU (see (ML) MODE SELECTION FRAME
Ê
FUNCTION =>
1
2
3
4
X
U41859-J-Z126-2-76
The following function is executed after the corresponding character
has been entered and the [ENTER] key has been pressed:
RATE CONTROL
ADRS COMPARE STOP
3 FIRM DUMP
HSA DUMP
EXECUTE
defines program operation
sets mode for compare address stop
outputs a firmware dump to tape, MTC or an
emulated tape device
(for Customer Support only)
executes HSA dump (for Customer Support only)
(HSA Hardware/Software Area)
executes functions 1 - 4
SVP frames and subframes
page 24)
35