Activating The Network Management Port - Fujitsu SPARC Enterprise T2000 Administration Manual

1 stop bit
■
No handshaking
■
2. Establish an ALOM CMT session.
See the ALOM CMT guide for your server for instructions.
3. To connect to the system console, at the ALOM CMT command prompt, type:
sc> console
The console command switches you to the system console.
4. To switch back to the sc> prompt, type the #. (Pound-Period) escape sequence.
ok #.
Characters are not echoed to the screen.
For instructions on how to use the ALOM CMT system controller, refer to the ALOM
CMT guide for your server.

Activating the Network Management Port

The network management port is configured by default to retrieve network settings
using DHCP and allow connections using SSH. You may need to modify these
settings for your network. If you are unable to use DHCP and SSH on your network,
you must connect to the system controller using the serial management port to
reconfigure the network management port. See
on page 7
Note – There is no default password when connecting to the system controller for
the first time using the serial management port. When connecting to the system
controller using the network management port for the first time, the default
password is the last 8 digits of the Chassis Serial Number. The Chassis Serial
Number can be found printed on the back of the server or in the printed system
information sheet which shipped with your server. You must assign a password
during initial system configuration. For more information, refer to your server
installation guide and the ALOM CMT guide for your server.
8 SPARC Enterprise T2000 Server Administration Guide • April 2007
"Using the Serial Management Port"