Performing A System Dump - Fujitsu BS2000 SE Series Operating Manual

Performing a system dump

–
–
–
6.2 Performing a system dump
Requirement:
SVP console opened and ready
1. Select (LD) PROGRAM LOAD FRAME
2. Select LOAD FUNCTION => 5 (SYSTEM DUMP)
The memory dump stored by the DUMP program to disk or tape is required for error
diagnosis.
The BS2000/VM2000 system must subsequently be reloaded by means of IPL.
i
82
A warning has been displayed, e.g. when the room temperature is too high.
The cause of the fault must be rectified. System operation can continue in the
meantime.
A fault which has automatically been corrected by the hardware occurred on the
server or at the interface to the peripheral devices. In this case, too, system
operation can continue.
A fault has occurred which does not permit system operation to continue. In this
case you can respond as follows:
When system downtime occurs, perform an MPL. If this does not rectify the fault,
notify Customer Support and discuss how to proceed further.
Information on SLED operation is provided in the "Introduction to System Adminis-
tration" manual [8].
What to do if ...
U41859-J-Z126-2-76