Fujitsu BS2000 SE Series Operating Manual page 29

Operating the service processor
Before completing this frame, check whether the correct firmware for operating Native
BS2000 or VM2000 has been loaded by the SVP. Information on this is provided in the
DETAIL-2 STATUS field.
DETAIL-2 STATUS
If the setting is not correct, click on [PF9] to correct the entry in PROGRAM LOAD FRAME:
DETAIL-2. After you have made the correction and clicked on [PF9], the setting is stored
and you are returned to this frame (see
If the setting is correct, complete this frame and execute the IPL.
LOAD FUNCTION ==> The following function is selected after the corresponding number
1
2
3
4
5
6
7
Functions 6 or 7 must be used for an IPL from a real or emulated tape device. In
addition, function 3 must be selected at MT CONTROL (see
U41859-J-Z126-2-76
In this position the current settings of the PROGRAM LOAD
FRAME: DETAIL-2 are displayed.
important display
VM MODE:
NATIVE
AVM/EX
has been entered:
START AUTO
START FAST
START DIAL
START
SYSTEM DUMP
LOAD CLEAR
LOAD NON CLEAR
Loaded firmware
for BS2000 operation
for VM2000
page 32).
executes IPL: automatic startup
executes IPL: fast startup
executes IPL: dialog startup
not used
executes SLED
clears main memory before IPL
does not clear main memory before IPL
SVP frames and subframes
page 31).
29