Fujitsu BS2000 SE Series Operating Manual page 33

Operating the service processor
Frame-specific functions
[ENTER] Sets operating mode.
[RETURN] Swap to PROGRAM LOAD FRAME: BASIC (see
[PF9] Swap to PROGRAM LOAD FRAME: DETAIL-1 (see
U41859-J-Z126-2-76
After selecting the firmware to be loaded in the
Ê
in the
2 IPL EXECUTION ==>
The following prompt appears on the screen:
***********************************
*
* ARE YOU SURE ? (ENTER Y OR N) N *
*
***********************************
v
CAUTION!
The operating mode must not be reset during system operation!
If this instruction is not heeded, BS2000 will be aborted!
Press the [Y] key to reload the firmware, or the [N] key to cancel the procedure.
Ê
Confirm your entry with the [ENTER] key.
After reloading the firmware, click on the [PF9] key to carry out IPL in
Ê
PROGRAM LOAD FRAME: DETAIL-1.
changes you have made.
VM MODE ==>
field, press the [ENTER] key.
*
*
SVP frames and subframes
field and entering
page 27)
page 28) without saving the
33