Options For Switching Between Frames - Fujitsu BS2000 SE Series Operating Manual

Operating the service processor

4.3.3 Options for switching between frames

The following table shows the options for switching to another frame in the SVP window.
Button
[INDEX]
[RETURN]
[ModSel]
Frame selection Enter a frame code in the MODE SELECTION FRAME
Change to
subframes
FR command
U41859-J-Z126-2-76
Effect
Only in CE mode: by clicking on this button you switch from any frame directly to
the index frame. The selection of the desired frame can then be made by entering
the frame ID in the index frame.
This button switches back to the previous frame or to the higher-level frame.
This button switches switches from any frame to the MODE SELECTION FRAME.
(e.g. ST, AU, AU5)
You can change to a subframe by selecting it from the main frame or from a
subframe that has already been invoked. This can be done:
– with SVP function calls (the buttons are shown in the corresponding frame or
subframe)
– by selecting a function with or without entering a parameter.
It is possible to switch to any frame with the FR command. The command is
entered in the command line (screen line 24) of a frame. It has the following format:
FR XX (XX is the code of the desired frame; see
Using SVP frames
figure 5 on page 22)
23