Fujitsu BS2000 SE Series Operating Manual page 63

Operating the service processor
In the example the PROGRAM LOAD FRAME: DETAIL-1 is displayed:
-LOAD FUNCTION-
RA
Figure 31: PROGRAM LOAD FRAME: DETAIL-1 screen
Before completing this frame, check whether the correct firmware for operating Native
BS2000 or VM2000 has been loaded by the SVP. Information on this is provided in the
DETAIL-2 STATUS field.
DETAIL-2 STATUS
Swap to PROGRAM LOAD FRAME: DETAIL-2
For this example, go to the
FRAME: DETAIL-2" on page 66
U41859-J-Z126-2-76
----- PROGRAM LOAD FRAME: DETAIL-1 -----
==>
*1 START AUTO
*2 START FAST
*3 START DIAL
*4 START
*5 SYSTEM DUMP
*6 LOAD CLEAR -----+
*7 LOAD NON CLEAR -+
|
+MT CONTROL-
PARMS=>
>*1 NL
CL-0
-IPL DEVICE-
==> 2
*1 PRESET GROUP ------------------+
>*2 CURRENT GROUP --------+
*3 UNIT ADDRESS -+
--- DETAIL-2 STATUS ---
==> 1
*2 SL
*3 NL-REWIND
*4 SL-REWIND
CPU-0 CHP-0
The settings in DETAIL-2 FRAME are displayed here.
Check the settings. If the settings are correct, complete this
frame and execute the Initial Program Load by pressing the
[ENTER] key.
If the settings are not correct, correct them in DETAIL-2
FRAME (see below).
In our example
VM MODE: NATIVE
BS2000 operation, is loaded. This setting must be changed
in DETAIL-2 FRAME for this example.
section "Setting operating mode via PROGRAM LOAD
and continue there.
Examples of SVP operation
E90L01G
+
A108 A108
XXXX
XXXX
XXXX
VM MODE : NATIVE
EXA MODE : ENABLE
IPL EXEC : ENABLE
*ENTER EXECUTE
*PF3 GO TO BASIC FRAME
*PF9 GO TO DETAIL-2
RUN
[]-[]00
, i.e. the firmware for
|
+
A108
XXXX
XXXX
XXXX
63