Using Svp Frames; Svp Functions (Function Keys) - Fujitsu BS2000 SE Series Operating Manual

Operating the service processor

4.3 Using SVP frames

You assign a job to the SVP by invoking the relevant frame, selecting the desired function,
and specifying the required parameters. To select a function or specify a parameter, you
must enter the alphanumeric characters shown in the frame in the input fields marked by
an arrow (=>). After an entry, the cursor automatically switches to the next entry field. You
can select entry fields manually with the tabulator key or arrow keys. Once you have
entered all the functions and parameters assigned to a job, press the [ENTER] key. In some
frames, SVP functions can also be initiated by actuating the corresponding function key
(also known as pfkey).
Instead of selecting a function, you can also enter a command in the command input line in
all frames (screen line 24) and assign a job to the SVP in this way. Frames can also be
selected using the
in upper or lower case). A command entered in line 24 takes priority over a selected frame
function.

4.3.1 SVP functions (function keys)

A virtual keyboard is available to you for making entires on the SVP console.
Click the keyboard icon at the top right to open the virtual keyboard. Clicking the icon
Ê
again closes the keyboard.
Function keys (pfkeys) [PF1] through [PF24] and [Clear] and [Cancel] are located in the
upper part of the virtual keyboard. You can trigger the corresponding SVP functions by
clicking with the mouse.
U41859-J-Z126-2-76
, e.g.
FRËFrame-ID FR ML
(to switch to the MODE SELECTION FRAME,
Using SVP frames
19