Box Controller On And Reset Switches - Teledyne ADFM Pro20 Installation And Operation Manual

2.10.2 Box Controller On and
Reset Switches
Figure 2-58 Control box power switches
In the box controller, the On switch is a key switch located on the
left side of the inner front panel (Figure 2-58), inside the area
labeled Power. Note that there are two switches, labeled Battery
and Mains. Only the switch labeled Battery is functional.
This switch controls all DC power, including batteries and
external power. The Mains switch is not connected or functional,
since current ADFM units do not use line voltage.
To power up the ADFM, use the switch-key provided to turn the
"Battery" switch to the On position, indicated by the number 1
(one).
Power switch (both bat-
tery and external DC)
To reset the ADFM, turn the spring-loaded Reset switch to the 1
(one) position and release it.
ADFM® Flow Meter
Section 2 Setup and Installation
Not functional;
do not use
2-53