Circular Channels - Teledyne ADFM Pro20 Installation And Operation Manual

Figure 2-28 Securing the cable(s) with SST straps

2.6.4 Circular Channels

Cable mounting kit, Pro20 only:
part #60-7709-003
Cable mounting kit, Pro20 + pressure sensor:
part #60-7709-002
Note
Always secure the sensor cable to the mounting apparatus and
channel wall. Permanent installations require the use of
bolted stainless steel straps. Plastic cable ties alone are not
recommended for any installation, but if used, should have
minimum 50 lb loop strength.
For large ID pipes and manhole inverts, Isco's adjustable Scissors
Ring (also known as the Universal Mounting Ring) is available in
sets consisting of a base section, a scissors mechanism for
adjustment, and one or more pairs of extensions to fit the specific
channel size. The base section is equipped with holes and tabs for
mounting other Isco sensors.
Note
Complete information about the Scissors Ring is beyond the
scope of these instructions. See the Isco Mounting Rings
Installation and Operation Guide (available at www.isco.com)
or call the factory for details about choosing and installing your
configuration.
ADFM® Flow Meter
Section 2 Setup and Installation
Lock nut
Flat washer
Flathead
screw
Isco mounting
ring
2-29