2.10 Applying Power
2.10.1 Box Controller
Batteries
Figure 2-55 Box controller: remove the battery
compartment
Connect the appropriate power supply to the ADFM and the
power source, and/or ensure that the batteries are securely
mounted inside the control box.
To install the four lantern batteries:
1. Remove the top cover by loosening the four large screws
holding it in place.
2. Remove the two small, flathead screws holding the inner
front panel closed. The screws are not attached. Take care
not to lose the plastic washers.
3. Remove the battery housing lid by loosening the four large
screws holding it in place. The screws remain attached to
the lid.
ADFM® Flow Meter
Section 2 Setup and Installation
Loosen screws
(4)
2-51