Teledyne ADFM Pro20 Installation And Operation Manual page 37

Figure 2-15 Real-time Data screen
Note
If error messages appear when you select Quick Data or Pro-
gram and Go, typical causes are a disconnected sensor cable
and/or invalid station file settings. Ensure that the sensor is
properly connected and that Channel Properties, as well as all
other station file settings, are valid, and retry.
6. When the Real-time Data screen appears (Figure 2-15),
click Exit. Disconnect the interface cable and exit the Oper-
ate screen. Exit the WinADFM software program.
For an overview of data retrieval, turn to Section 2.14.
Note
For complete information on programming and data retrieval,
refer to the WinADFM software manual.
ADFM® Flow Meter
Section 2 Setup and Installation
2-17