Installing Equipment - D-Link DSR-500N Quick Installation Manual

LED Color Status
Indicators
Power / Orange/ Solid
Status Green Orange
Solid Green Completion of power on
Blinking
Orange
Blinking
Green
Light Off
2.4GHz/ Green Steady
5GHz Green
WLAN
Blinking
Green
Light Off
USB Green Solid Green The link is good
Blinking
Green
Light Off
WPS Blue Blinking
Blue
Solid Blue
Light Off
TX/RX Green Light Off
Status
Solid Green Link present.
Blinking
Green
LINK Green/ Light Off
Speed Orange
Solid Green Port is operating at
Solid
Orange
Table 2. Device Status LED Descriptions
DSR-500N/1000N Default Interface Settings
Ethernet
Interface Interface Type
LAN(1-4) / Static IP
WLAN
WAN1 DHCP Client
WAN2 DHCP Client
(Configurable (default)
port)
Static IP (When
it's configured
as DMZ)
Table 3. Default Interface Settings
Note: D-Link Wireless N Services Router only
allow Web GUI access from LAN and WLAN
interfaces by default for security reason.
The WAN2 is a configurable port which support
various and advanced scenario applications.
When WAN2 port is configured as DMZ port, the
IP address will be changed to 172.17.100.254.
Description
Device during power-on
process
Device is crashed and
under recovery mode
The system is defective,
such firmware upgrades
fail.
The device is power-off
The link is good
There is activity on
this port
No link
There is activity on
this port
No link
Start to process
The connection is
successfully established
No Link.
No Link.
Port is sending or
receiving data.
Port is operating at
10Mbps.
100Mbps
Port is operating at
1000Mbps
Web-Based
IP Address Management
192.168.10.1/24 Enabled
0.0.0.0/0 Disabled
0.0.0.0/0 Disabled
172.17.100.254/24 Disabled
Installing and Connection
This chapter describes how to install a
DSR-500N/1000N device in a standard 19-inch
equipment rack and how to connect cables and
power to the device.
Before You Begin
Observe the following precautions to help prevent
shutdowns, equipment failures and injuries:
- Before installation, always check that the power
supply is disconnected.
- Ensure that the room in which you operate the
device has adequate air circulation and that
the room temperature does Not exceed 40
(104 C)
o
- Allow 1 meter (3 feet) of clear space to the front
and back of the device.
- Do not place the device in an equipment rack
frame that blocks the air vents on the sides of
the chassis. Ensure that enclosed racks have
fans and louvered sides
- Correct these hazardous conditions before
any installation: moist or wet floors, leaks,
ungrounded or frayed power cables, or missing
safety grounds.

Installing Equipment

You can mount the DSR-500N/1000N device into
a standard 19-inch equipment rack. To install an
appliance into a rack:
1. Attach the mounting brackets to each side of
the chassis as shown in figure 3 and secure
them with the screws provided.
Figure 3. Attaching Rack Mount Brackets
D-Link Wireless N Services Router  33
C
o