Installing Tranceivers Into The Transceiver Ports; Power On (Ac Power) - D-Link DGS-1510 Series Hardware Installation Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide

Installing Tranceivers into the Transceiver Ports

The Switch is equipped with SFP (Small Form Factor Portable) and SFP+ ports, which are used with
fiber-optical transceiver cabling.SFP ports support full-duplex transmissions, auto-negotiation, and can be
uplinked with various other switches across a gigabit network. The SFP ports support data rates of up to
1Gbit/s and the SFP+ ports support data rates of up to 10Gbit/s.
See the figure below for installing the transceiver in the transceiver port on the Switch.
For a full list of supported transceivers, compatible with this switch series, refer to

Power On (AC Power)

Plug one end of the AC power cord into the power socket of the Switch and the other end into the local
power source outlet. After the system powered on, the LED's blink green to indicate that the system is
booting up.
CAUTION: Installing systems in a rack without the front and side stabilizers installed could
cause the rack to tip over, potentially resulting in bodily injury under certain circumstances.
Therefore, always install the stabilizers before installing components in the rack. After
installing components in a rack, do not pull more than one component out of the rack on
its slide assemblies at one time. The weight of more than one extended component could
cause the rack to tip over and may result in injury.
Figure 2–4 Inserting fiber-optic transceivers into a Switch
20
Port Functions.