Otto Bock E-MAG Active 17B202N Mounting And Service Instructions page 53

Remove the Vulkolan® tape and fasten the dummy
tronics with receptacle with double-sided adhesive tape.
Fill the edges between the dummies and the socket with Plastilin® in order to achieve a smooth
transition (Figure 28).
Pull one layer of nylon stockinette 99B25 over the finished orthosis on the plaster model. In this
way, the
lower layer of PVA foil
Reinforce the casing as follows:
a)
lower layer of PVA foil,
b) 2 layers of perlon stockinette,
INFORMATION
The carbon maintains the tension of the shell and secures the dummies and screw connections.
c) 2 additional layers of perlon stockinette.
d)
upper layer of PVA foil
Then laminate the casing with an appropriate amount of lamination resin.
Wait until the casing has hardened.
Drill the boreholes for the screw connections on the lamination plates from the outside (Figure 30)
and tap a 4 mm thread into the holes (Figure 31). Then countersink the screws by turning them
E-MAG Active
26
will be siphoned off evenly (Figure 29).
28
with carbon.
reinforced
.
for battery with receptacle and dummy for
27
elec-
29
Ottobock | 53