Casing - Otto Bock E-MAG Active 17B202N Mounting And Service Instructions

This will create an optimal support surface for the electronic components.
Once the lamination has hardened, fabricate the casing on top of the transfemoral lamination.

3.2 Casing

This section describes how to fabricate a casing for the protection and retention of cables and
electronic components.
INFORMATION
The marked casing support is essential for stability (also see Figure 22/23).
First cut the knee joint dummy free as illustrated in Figure 21. Remove the knee joint dummy.
NOTICE
Risk of damage due to improper installation. Incorrect installation can cause improper operation
and / or damage to the knee joint. Please observe the following safety instructions:
• Follow the installation instructions and the sequence of the individual steps (see Section 3.1).
• Use the supplied dummies. Do not process joint or electronic components directly.
• Follow the instructions for use provided for the charger and batteries.
E-MAG Active
19
21
20
Ottobock | 51