Maintaining The Hopper And Rear Gate; Checking The Conveyor Seals And Rear Gate Seal; Checking The Rear Gate; Cleaning - Toro MH-400SH2 Operator's Manual

Maintaining the Hopper
and Rear Gate
Checking the Conveyor
Seals and Rear Gate Seal
Service Interval: Before each use or daily
Check all rubber seals for damage or wear.
Replace or repair the seals if they are damaged or
excessively worn.

Checking the Rear Gate

Service Interval: Before each use or daily
•
Check that the rear gate closes and latches
securely.
•
Check that the adjustable section of the rear gate
opens and closes without sticking.

Cleaning

Washing the Machine

Salts, road tar, tree sap, fertilizers, or chemicals may
damage the painted finish of the machine. Wash off
these deposits as soon as possible with detergent and
water. Additional cleaners or solvents may be needed,
but ensure that they are safe for painted surfaces.
WARNING
Flammable fluids and cleaners with toxic
vapors are hazardous to your health.
Do not use flammable fluids or cleaners with
toxic vapors. Follow the manufacturer's
recommendations.
Important:
Do not use a high-pressure washer.
This can remove paint, safety decals, and grease,
and can also damage components.
1. Remove the option before cleaning and wash
it separately.
2. Remove the handheld remote.
3. Wash the body of the machine with warm water
and a mild detergent
4. Completely rinse off the detergent residue with
clean water before it dries.
5. Remove the belt cleaning scraper assembly
from the rear of the machine
1. Belt cleaning scraper assembly
6. Raise the back of the machine if needed.
7. Fully open the rear gate and spray water inside
the hopper assembly and the rear gate area.
Inspect the side seals and replace if necessary.
8. Inspect the hopper, bottom guard, conveyor
belt, bed, and rollers to ensure that all trapped
material is gone.
9. Lower the machine to the normal operating
position.
52
(Figure 57).
Figure 57
g272507