Table of Contents
Advertisement
1.
Read and understand the information in the
installation and operating instructions of the
brake controller.
2.
Set up the brake controller; refer to the
installation and operating instructions of the
brake controller.
Before Operations Checks
Complete these checks daily before operating
the machine. Report any safety problems to your
supervisor. See the Safety Instructions in this manual
for details.
•
Check the tires and wheels; refer to
Tire and Wheels (page
•
Check that the rear-jack leg is stowed and the jack
is stowed to the hitch tube; refer to
Rear-Jack Leg (page 26)
(page
27).
•
Check that the hitch pin and jacks are not
damaged, and the safety pins are installed.
Replace missing or damaged safety pins.
•
Check the rear gate for wear, damage, and is
secure; refer to
Checking the Rear Gate (page 52)
and
Checking the Conveyor Seals and Rear Gate
Seal (page 52)
•
Check the optional attachments for wear, damage,
and are secure; refer to
Attachments (page 48)
During Operation
During Operation Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Do not operate the machine when tired, ill, or
under the influence of alcohol or drugs.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
•
Keep your hands and feet out of hopper while the
machine is operating or engine is running on the
tow vehicle.
Checking the
44).
Stowing the
and
Stowing the Jack
Checking the Optional
•
Remain seated whenever the tow vehicle is in
motion.
•
Using the machine demands attention. Failing
to operate tow vehicle safely may result in an
accident, tip-over of the tow vehicle, and serious
injury or death. Drive carefully, and to prevent
tipping or loss of control, do the following:
– Use extreme caution, reduce the speed, and
maintain a safe distance around sand traps,
ditches, water hazards, ramps, unfamiliar
areas, or other hazards.
– Reduce the speed of a loaded machine when
negotiating terrain undulations to avoid causing
the machine to become unstable.
– Watch for holes or other hidden hazards.
– Use caution when operating on a slope. Travel
straight up and down slopes. Reduce speed
when making sharp turns or when turning on
hillsides. Avoid turning on hillsides whenever
possible.
– Use extra caution when operating on wet
surfaces, at higher speeds or with a full load.
Stopping time increases with a full load. Shift
into a lower gear before starting up or down
a hill.
– Avoid sudden stops and starts. Do not go
from reverse to forward or forward to reverse
without coming to a complete stop.
– Do not attempt sharp turns or abrupt
maneuvers or other unsafe driving actions that
may cause a loss of control.
– Be aware of your surroundings when turning
or backing up the machine. Ensure that the
area is clear and keep all bystanders out of the
operating area. Proceed slowly.
– Watch out for traffic when near or crossing
roads. Always yield the right of way to
pedestrians and other vehicles. Obey all traffic
rules and check for local regulations on the
operation of the machine on or near highways.
– Always watch out for and avoid low overhangs
such as tree limbs, door jambs, overhead
walkways, etc. Ensure that there is enough
room over head to easily clear the tow vehicle
and your head.
– Do not operate the machine when there is the
risk of lightning.
– If you are ever unsure about safe operation,
stop working and ask your supervisor.
– Do not leave the machine unattended while it
is running.
•
Ensure that the machine is connected to the tow
vehicle before loading.
23
Advertisement
Table of Contents
