Table of Contents
Advertisement
11
Assembling an Optional
Attachment to the Machine
Parts needed for this procedure:
2
Quick attach mounting clamp
Procedure
1. Rear of the machine
2. Option attachment bracket
3. Lock pin
4. Lock ring
5. Clamp handle
6. Safety latch clip
7. Safety latch
Important:
The option attachments are heavy.
Use an assistant to help lift them.
Note:
The machine comes equipped with 2 quick
attach mounting clamps. Use these clamps to mount
the optional accessory to the machine.
1.
Remove the safety latch clips from the clamp
handles
(Figure
15).
2.
Lift the safety latch, then lift the option
attachment clamp handles, and release the lock
rings from the lock pins
3.
Slide the rear option attachment clamp assembly
out of the quick-attach slots
Figure 15
(Figure
15).
(Figure
15).
8. Option
9. Lift
10. Pull
11. Rear clamp assembly
12. Support the option before removing the clamps
13. Front clamp brackets
4.
With assistance, insert the front edge of the
option attachment up and under the rear of the
machine into the front clamps on the brackets
(Figure
15).
5.
While supporting the option attachment, slide
the rear option attachment clamp assembly back
into the slots in the brackets, and over the rear
edge
(Figure
15).
6.
Ensure that the option attachment is centered
between the brackets. Then assemble the lock
rings over the lock pins and push down on the
clamp handles.
17
g015127
Advertisement
Table of Contents
