Caring For The Handheld Remote; Replacing The Batteries In The Handheld Remote - Toro MH-400SH2 Operator's Manual

Note:
There are 3 settings: O
Decreasing the Contrast
Hold the A S and the O
LL TOP
simultaneously while observing the display until the
contrast is as desired.
Note:
There are 3 settings: O
Increasing Backlighting
Press the A S and the F
LL TOP
simultaneously while observing the display until the
backlighting is as desired.
Note:
Display backlighting consumes the most
energy of all handheld remote functions. Increasing
the backlighting increases power consumption, and
shortens the life of the batteries; the decrease the
handheld remote backlighting for longer battery life.
Decreasing Backlighting
Press the A S and the F
LL TOP
simultaneously while observing the display until the
backlighting is as desired.
Checking the Battery Life,
Operating Frequency, Base and
Remote ID Display
Hold down the A S
LL TOP
buttons simultaneously to display multiple points of
information.
As you hold the buttons down, the display cycles
approximately every 2 seconds displaying first the
battery life expectancy in percent remaining or current
+
, L , and H
FF OW IGH
D buttons
PTION ECREASE
+
, L , and H
FF OW IGH
I buttons
LOOR NCREASE
+
D buttons
LOOR ECREASE
+
and O S
PTION TOP
+
battery voltage, the operating frequency (channel)
on which the units communicate, then the handheld
remote ID number, and finally the associated BASE
Unit ID.
.
Caring for the Handheld
Remote
Though the handheld remote is rugged, do not to
drop it on hard surfaces. Wipe the handheld remote
clean using a soft cloth moistened with water or a mild
cleaning solution. Avoid scratching the LCD screen.
Replacing the Batteries in
.
the Handheld Remote
The handheld remote is powered by 4 batteries (size
AA alkaline, 1.5 V each) and operates between 2.4
to 3.2 V. Battery life is approximately 300 hours
(continuous operation with the backlight off), but
battery life longevity is affected by usage factors,
particularly backlight intensity setting—the higher the
backlight setting, the more power consumed resulting
in shorter battery life.
Important:
When using the handheld remote,
always keep fresh spare batteries at hand.
1. Loosen the bolt in the magnet on the magnetic
remote bracket
1. Handheld remote
2. Magnetic remote bracket
2. Slide the bracket sides apart and remove the
remote (Figure
3. Remove the 6 screws from the back of the
remote and remove the cover
35
(Figure 41).
Figure 41
3. Bolt in the magnet
41).
(Figure
g028874
42).