Toro MH-400SH2 Operator's Manual page 33

Adjusting the Floor Speed
1. Loosen the jam nut at the manual-override
bracket (Figure 35).
1. Stem (floor-speed
solenoid)
2. Hex-head screw (valve
override)
2. Rotate the hex-head screw for the valve override
clockwise to increase the floor speed
35).
Note:
Use the maximum-floor speed of the
color-coded operation system when you have no
hydraulic flow. This setting is also helpful when
the hopper is full of sand.
3. When the machine is running at the correct floor
speed, tighten the jam nut.
Adjusting the Position of the Hopper
•
To lower the hopper
the valve stem.
Figure 35
3. Jam nut
(Figure
(Figure 36), pull the ring on
g285594
1. Split ring (valve stem)
2. Lower the hopper
•
To raise the hopper
on the valve stem.
Adjusting Accessory Attachment Speed
1. Rotate the hex-head screw for the valve override
clockwise to increase the floor speed
37).
Note:
If you are adjusting the machine with
the hydraulic flow active and do not want sand
spread as you adjust, ensure that the floor is
turned off.
1. Hex-head screw (valve override)
33
Figure 36
3. Raise the hopper
(Figure 36), push the split ring
(Figure
Figure 37
g285595
g285593