Table of Contents
Advertisement
2.
Once your settings are acceptable, use the
hydraulic flow control on your tow vehicle to turn
the system on and off during operation.
Resetting Manually Overridden
Hydraulic Controls
EH Models
If you found, repaired, or replaced the handheld
remote, reset the floor-speed solenoid,
attachment-speed solenoid, or both before
controlling the machine with the handheld remote.
Reset the Floor-Speed Solenoid
EH Models
1.
Loosen the jam nut at the manual-override
bracket
(Figure
38).
Figure 38
1. Stem (floor-speed
solenoid)
2. Gap
2.
Rotate the hex-head screw for the valve override
counter clockwise until you see a small gap
between the end of the screw and the end of the
stem of the floor-speed solenoid
3.
Tighten the jam nut
Reset the Attachment-Speed Solenoid
Rotate the flat-head screw counterclockwise until the
valve in the solenoid is fully open
3. Hex-head screw (valve
override)
4. Jam nut
(Figure
38).
(Figure
38).
(Figure
39).
1. Hex-head screw (valve override)
Installing the Cover Plate
Secure the cover plate to the override cover with the 4
flange-head capscrews
g285597
1. Right side of the machine
2. Override cover
Liquid Crystal Display (LCD)
The 2-line, 8 character-per-line LCD (liquid crystal
display) shows status and activity as you press the
buttons of the handheld remote. It features user
adjustable backlighting and contrast. The changes are
saved in the current working memory of the remote.
After the unit is powered down, the display uses the
last settings for contrast and backlighting when you
turn on the unit.
Increasing the Contrast
Hold the A
S
LL
TOP
simultaneously while observing the display until the
contrast is as desired.
34
Figure 39
(Figure
40).
Figure 40
3. Cover plate
4. Flange-head capscrew
and the O
I
PTION
NCREASE
g285593
g285427
buttons
Advertisement
Table of Contents
