Table of Contents
Advertisement
current working memory setting stored in the
handheld remote.
2.
Press the same start button a second time to
turn on the component if the hydraulics are
engaged (it shows numbers ramping up in
the display).
3.
Press the same start button a third time
to store the new setting established in the
working memory of the remote.
•
After pressing a start button once to view the
current working memory setting in a non-working
mode, you have approximately 10 seconds to
begin adjusting the setting or the element before
the remote reverts to off. In a working mode, the
10-second rule does not apply.
•
To program a preset, you must have the elements
activated or engaged first.
•
To operate from a preset, the you see the element
speed percentages in the display to activate or
engage them. If you see the word OFF in the
display, you must recall the preset.
Manually Overriding the Hydraulic
Controls
EH Models
If the handheld remote is missing, damaged, or fails,
you can still operate the machine to complete tasks or
continue a spreading job.
Preparing the Machine
1.
At the right side of the machine, remove the 4
flange-head capscrews that secure the cover
plate to the override cover
1. Right side of the machine
2. Override cover
(Figure
32).
Figure 32
3. Cover plate
4. Flange-head capscrew
2.
Ensure that the parking brake is engaged, start
the traction unit, and supply hydraulic pressure
to the machine.
3.
Locate the 3 control valves
1. Floor-speed solenoid
2. Raise/lower hopper
solenoid
Note:
Refer to the decal located on the cover
plate
(Figure
1. Adjust floor speed
2. Lower the hopper
3. Raise the hopper
g285427
32
(Figure
Figure 33
3. Attachment-speed
solenoid
34).
Figure 34
4. Adjust spinner speed
5. Cover plate
6. Decal
33).
g285426
g285596
Advertisement
Table of Contents
