6
Installing the Pendant
Switch
SH Models
Parts needed for this procedure:
1
Pendant switch
1
SH wire harness
Procedure
Plug the on/off pendant switch (4 prong end) into the
socket at the front left corner of the machine
12).
Figure 12
1. On/off pendant switch
Important:
Always unplug the pendant switch
cord or disconnect the power-supply wire
when the machine and traction unit are not
used—otherwise the battery of the traction unit
loses power.
7
Assembling the Handheld
Remote
EH Models
Parts needed for this procedure:
1
Handheld remote
4
AA batteries
1
Magnetic bracket
6
Screws, small
Procedure
(Figure
1.
Remove the rubber bands securing the remote
halves together, and remove the back cover.
2.
Plug each battery into a terminal cradle
observing proper polarity. (If the batteries
are improperly installed, the unit will not be
damaged, but it will fail to operate.) The cradle
is embossed with polarity markings for each
terminal
g014074
1. Rubber seal
2. Steel gasket
3.
Ensure that the steel gasket and rubber seal are
seated in the channel in the remote and set the
back cover in place
15
(Figure
13).
Figure 13
3. Handheld remote
4. 4 AA batteries
(Figure
13).
g028875