Table of Contents
Advertisement
Troubleshooting
Checking Fault Codes
EH Models
If the Diagnostic LED indicates that there is a system fault (refer to
the fault codes to determine what is wrong with the machine.
Entering Diagnostic Mode and Checking the Codes
1.
Push the E-S
TOP
2.
Pull the tethered cap off the two diagnostic, shunt connectors
3.
Connect the diagnostic, shunt connectors together
4.
Pull the E-
up to turn on the power.
STOP
5.
Count the number of flashes to determine the fault code, then consult the following table:
Note:
If there are multiple faults, both faults will flash, then a long pause, then the flash sequences
will repeat.
button down to turn off the power.
Diagnostic LED Function (page
(Figure
(Figure
58, B).
Figure 58
54
58, A).
19)), check
g028876
Advertisement
Table of Contents
