Table of Contents
Advertisement
Handheld Remote Messages
EH Models
Displayed Message
ASSOC PENDING
ASSOC ACTIVE
POWER UP BASE
ASSOC PASS
ASSOC EXIT
ASSOC FAIL
PRESS STORE
ALL STORE
OPTION STORE
BELT STORE
PRESET 1 STORE
PRESET 2 STORE
PRESET 3 STORE
WAITING FOR BASE
HOPPER UP
HOPPER DOWN
PROPASS REV XX
MH400 REV XX
BAT XX%
Battery X.X V
CHANNEL X
HH ID XXXXXX
BASE ID XXXXXX
FLR XX%
OPT XX%
FLRS XX%
OPTS XX%
FLR OFF
OPT OFF
SERVICE ACTIVE
SERVICE NO APP
Description
Association yet to be made.
Association attempt in progress.
Power up the Base Unit.
Association attempt was successful.
Exiting Association mode
Association attempt failed.
Press the S
button.
TORE
Store all current set values in current working memory.
Store the current Option settings in current working memory.
Store the current Floor settings in current working memory.
Store the current Preset 1 setting in current working memory.
Store the current Preset 2 setting in current working memory.
Store the current Preset 3 setting in current working memory.
Remote is waiting for a Base Unit response.
Remote is sending Hopper Raise command.
Remote is sending Hopper Lower command.
Product to which the system is set to control.
Product to which the system is set to control.
Remaining battery life in percentage.
Remaining battery life in voltage.
Channel in GHz currently used by the system.
Identity of the Handheld Remote
Identity of the Base Unit
The current Floor speed in percent.
The current Option speed in percent.
Display of the stored regular Floor speed and Option speed with 0% command to the
output allowing the operator to decide to use the current setting or change it.
Displays the status of the floor and option when they are off.
The service tool is active.
Service has no valid application to run.
56
Advertisement
Table of Contents
