Shutting Off The Engine; Operating The Hopper; Removing Debris From The Machine; Lowering The Hopper Without Power - Toro MB TX 2500 Operator's Manual

Shutting Off the Engine

1. Move the throttle between the F
positions.
2. Engage the parking brake.
3. Turn the key switch to the O
remove the key.
Figure 11

Operating the Hopper

Hopper capacity: 1134 kg (2,500 lb)
Know the load capacity of the machine and never
exceed it. This machine normally operates on uneven,
unpaved, bumpy, and/or inclined surfaces—adjust the
load accordingly.
1. Position the machine where you intend to dump
the load.
2. Dump the hopper by pushing the top of the
dump switch (Figure
3. Lower the hopper by pushing the bottom of the
dump switch (Figure
Note:
If you hold the bottom of the switch
0.2 to 1.3 seconds, the hopper fully lowers
automatically.
Figure 12
1. Dump the hopper.
and S
AST LOW
position and
FF
12).
12).
2. Lower the hopper.
Removing Debris from the
Machine
1. Park the machine on a level surface, move
the motion-control levers to the N
position, engage the parking brake, and lower
the hopper.
2. Shut off the engine and remove the key. Allow
the engine to cool.
3. Clean the inside of the hopper using a hose.
4. Clean any debris from under the hopper.
5. Wipe away debris from the air cleaner.
6. Clean any debris buildup on the engine and in
the transmission with a brush or blower.
Important:
it out. If you use water, keep it away from
electrical parts and hydraulic valves. Do not
use a high-pressure washer. High-pressure
g038314
washing can damage the electrical system
and hydraulic valves or deplete grease.
Lowering the Hopper
without Power
1. Install the cylinder lock; refer to
Cylinder Lock (page
2. Ensure that the tub is empty.
3. Place a large drain pan under the
hydraulic-manifold block
1. Hydraulic-manifold block
4. Disconnect the hose fittings in the manifold
block and allow the fluid to drain into the pain.
Note:
Dispose of the used fluid at a certified
recycling center.
5. Connect the hose fittings.
g038270
6. Use a hoist or have 2 people hold up the hopper
and remove the cylinder lock.
7. Carefully lower the hopper to the machine frame.
15
EUTRAL
Blow out dirt rather than wash
Installing the
18).
(Figure 13).
Figure 13
-
LOCK
g186548