Table of Contents
Advertisement
Note:
If possible, leave the rubber seal and
steel gasket in the channel when removing the
cover and batteries.
1. Rubber seal
2. Steel gasket
4.
Remove the discharged batteries and properly
dispose in accordance with local regulations.
5.
Install the batteries into the terminal cradle
observing proper polarity. The cradle is
embossed with polarity markings for each
terminal
(Figure
Note:
If you install the batteries incorrectly, the
handheld remote will not operate.
6.
If you accidentally removed the rubber seal and
the steel gasket, replace them carefully into the
channel in the handheld remote
7.
Replace the cover and secure it with the 6
screws removed previously
torque them to 1.5 to 1.7 N∙m (13 to 15 in-lb).
8.
Install the handheld remote into the magnetic
remote bracket, slide the halves together to
secure the handheld remote, and tighten the
bolt in the magnet
Associating the Handheld
Remote with the Base
The factory initially associates the handheld remote
to the base allowing them to communicate; however,
there may be instances in the field when you must
associate a remote and a base unit again.
Figure 42
3. Handheld remote
4. 4 AA batteries
42).
(Figure
(Figure
42) and
(Figure
41).
1.
Press the E-Stop button to remove power from
the base unit and ensure that the handheld
remote is off.
2.
Stand near the base unit in clear line of sight.
3.
Simultaneously press and continue to hold the
O
/O
N
The handheld remote goes through its
initialization screens and settles on ASSOC
PENDING.
4.
Continue to hold both buttons and then
quickly release them when ASSOC ACTIVE is
displayed (approximately 4 seconds).
The display shows PRESS STORE.
5.
Press and hold the S
g028875
The remote displays POW UP BASE.
6.
While continuing to hold the S
out on the E-S
unit.
The handheld remote associates (links) with the
base unit. Upon success, the display shows
ASSOC PASS.
7.
Release the S
Important:
association failed.
Note:
View the handheld remote and base unit link
by holding down the A
buttons at the same time.
42).
The display cycles and indicates the selected channel
and the ID of the Base Unit.
Operating the Floor and
Option Using the Handheld
Remote
EH Models
Use the following procedures to set and operate the
machine floor and option (such as the twin spinner or
other attachment) as follows:
36
and the A
S
buttons.
FF
LL
TOP
+
button.
TORE
button to power up the base
TOP
button.
TORE
If the display shows ASSOC EXIT, the
S
and O
LL
TOP
+
button, pull
TORE
S
PTION
TOP
Advertisement
Table of Contents
