Table of Contents
Advertisement
The preview value and FLRS displays.
2.
Adjust the speed setting using the I
O
S
button or the D
PTION
PEED
S
button.
PEED
3.
Press the O
PTION
option.
4.
Press the O
PTION
option value.
The display shows OPTION STORE. The set
value is used whenever the option is started in
the future until you change the setting again.
Setting and Operating the Floor
and Option Together
Upon initially pressing the A
(when the option is not running), the remote display
shows the floor and option stored settings and an S is
displayed after FLR and OPT (in other words, FLRS
and OPTS), indicating that the handheld remote is
in a set-only mode. In this set-only mode, you can
adjust either setting up or down, but the floor and
option do not activate, remaining off. This allows you
to set the desired speeds or use the stored settings
without causing unwanted movement. After setting
the speeds, press the A
the floor and option at the chosen setting (if the
hydraulics are engaged, the floor and option start).
Press A
S
a third time to store the current value
LL
TART
in memory.
Note:
Changes to the settings while the floor and
option are running are immediately effective, but
they are temporary unless you store the new setting
by pressing A
S
LL
TART
setting. For instance, you make an adjustment while
the display shows FLRS and OPTS, press A
S
starting the floor and option at the adjusted
TART
setting, and then turn the handheld remote off without
pressing A
S
again, storing the change. The
LL
TART
next time you use the remote, the settings revert to
the previously stored values.
NCREASE
O
ECREASE
or
S
button to start the
TART
S
button to store the
TART
S
button
LL
TART
S
button to activate
LL
TART
again after changing the
LL
Note:
A 10-second timer starts when you press A
S
and set-only mode displays. If you do not press
TART
a button during the 10-second interval, the display
PTION
reverts to FLR and OPT, the previous state/value
displays, and uses the previous state/value. The timer
resets to 10 seconds if any button is pressed while the
handheld remote is in the set-only.
1.
Press the A
The preview values and FLRS and OPTS
display.
2.
Adjust the speed settings as follows:
•
Adjust the floor speed setting using the using
the I
D
ECREASE
•
Adjust the option speed setting using the
using the I
the D
3.
Press the A
option.
4.
Press the A
The display shows ALL STORE. The set value
is used whenever the option is started in the
future until you change the setting again.
Note:
store the settings using the A
If neither or only 1 is running, pressing the A
S
TART
the 1 that was not running. Nothing is stored,
and the previously stored floor and the option
settings display.
It is important to realize that the stored command
for the floor and option are used twice, once in
the event of an individual command using the
38
S
button.
LL
TART
F
S
NCREASE
LOOR
PEED
F
S
button.
LOOR
PEED
or
O
NCREASE
PTION
O
S
ECREASE
PTION
PEED
or
S
button to run the floor and
LL
TART
S
button to store the values.
LL
TART
You must run both the floor and option to
button either starts them both or starts
LL
button or the
S
button or
PEED
button.
S
button.
LL
TART
LL
Advertisement
Table of Contents
