Table of Contents
Advertisement
7.
Secure the rubber boot to the connector and to
the wire harness with a cable tie.
8.
Secure all loose harness wires with cable ties.
9.
If you are using a 4 wheel brake kit, remove the
10 amp fuse from the fuse holder and insert the
15 amp fuse.
5
Installing the EH Wireless
Control Mounting Bracket
on the Traction Unit
Model 44954 Only
Parts needed for this procedure:
1
Mounting bracket assembly
1
Backing plate
4
Flange head bolt, 5/16 x 1-1/2 inch
4
Flange head locknut, 5/16
Procedure
1.
For traction unit mounting, determine an
appropriate location for the handheld remote
mounting bracket. The surface should be flat
and solid.
2.
Using the backing plate as a template, locate,
mark, and drill 4 holes (11/32 inch diameter) in
the traction unit mounting surface.
3.
Attach the mounting bracket and backing plate
with 4 flange head bolts (5/16 x 1-1/2 inches)
and flange locknuts
(Figure 10
and
Figure
1. Handheld remote
2. EH handheld remote
mount
1. EH handheld remote backing plate
Note:
The wireless remote magnet can stick to any
metal component.
11).
14
Figure 10
3. Mounting bolts
Figure 11
g028873
g014103
Advertisement
Table of Contents
