Table of Contents
Advertisement
1. Mirror
4
Wiring and Installing to the
Traction Unit
Parts needed for this procedure:
1
Foot controller
1
Brake controller
1
Harness assembly
1
Socket bracket
4
Screw, 5/16 x 1 inch
4
Nut, 5/16 inch
6
Wire splices
10
Cable tie
2
Bolt, #10 x 7/8 inch
2
Nut, #10
1
Hose clamp
1
Fuse (15 A)
Selecting a Traction Unit
Select a traction unit that meets the specifications and
traction unit recommendations; refer to
(page 20)
and
Selecting a Traction Unit (page
Figure 7
Specifications
Installing the Brake Controller
Outcross Traction Units
1.
Mount the brake controller
lower left area of the dashboard with the 2 bolts
(#10 x 7/8 inch) and nuts (#10).
g015149
1. Brake controller
2.
Connect the Outcross wire harness connector to
the brake controller connector.
Refer to the Outcross traction unit Operator's
Manual for additional mounting and operating
instructions.
Installing the Brake Controller
Tractor Type Traction Units
Mount the brake controller to the dash or the fender
of the tractor with the 2 bolts (#10 x 7/8 inch) and
nuts (#10).
Installing the Wire Harness and
Brake Controller
Note:
Lay out the harness on the traction unit to
determine the mounting locations of the harness
components. Use cable ties to bundle surplus cable
lengths. Also, use the wire splices when altering the
harness length (shortened or lengthened). Heat the
shrink the connectors until they are tight to the wires.
Important:
to use the proper gauge wire.
1.
Mount the socket bracket to the rear of the
traction unit with 2 bolts (5/16 x 1 inch) and nuts.
2.
Route the wire harness connector through the
21).
hole to the socket.
12
(Figure
Figure 8
If you add wire to the harness, ensure
8) to the
g235379
Advertisement
Table of Contents
