Table of Contents
Advertisement
Media and Additional Parts
Description
Operator's Manual
Declaration of Conformity
Attachment clamps
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Installing the Hitch
Parts needed for this procedure:
2
Bolt, 1 x 6-1/2 inches
2
Locknut, 1 inch
Procedure
1.
Locate and remove the loose parts box shipped
on the fender.
2.
Remove the rear jack leg from the stowed
position and assemble the jack leg in the vertical
position; refer to
the Rear-Jack Leg (page
3.
Remove the hitch from the shipping position
by cutting both straps securing the hitch to
the fender
(Figure
brackets from the fender and discard.
1. Remove hitch from shipping position
Supporting the Machine with
25).
3). Remove both mounting
Figure 3
Qty.
1
Read the manual before operating the machine.
The Declaration of Conformity serves as EU proof of
1
certification.
2
Use to mount attachments.
Note:
assembly.
4.
Slide the hitch tube tongue into place at the front
of the machine. Ensure that the jack mounting
bracket faces out toward the left side.
5.
Place a bolt (1 x 6-1/2 inches) through the frame
and hitch tube and secure it with a locknut
(Figure
N-m (720 to 880 ft-lb).
6.
Place a bolt (1 x 6-1/2 inches) through the top of
the frame and down through the hitch tube and
secure it with a locknut
locknut to 976 to 1,193 N-m (720 to 880 ft-lb).
1. Hitch tube
7.
Remove the jack from the rear-jack leg and
install the jack onto the hitch tube; refer to
Supporting the Front of the Machine with the
Jack (page
Note:
Do not insert the pin through the vertical
hole of the jack, or you will not be able to remove
the pin when the weight case is installed.
g014065
10
Use
Use 2 people to remove the hitch
4). Torque the locknut to 976 to 1,193
(Figure
Figure 4
2. Mounting bolt and nut
27).
4). Torque the
g014066
Advertisement
Table of Contents
