Toro MH-400SH2 Operator's Manual page 31

Button
Starting the Handheld Remote
Press the O /O button on the remote and wait for
N FF
the it to find the base. Do not press any buttons on the
hand held while it is performing its startup routine.
Understanding the Remote Status
LED
EH Models
The remote status LED blinks slowly at 2 Hz (twice
per second) when the handheld remote is transmitting
but no buttons are pressed, when the floor and option
buttons are active. When you press a button, the light
blinks at 10 Hz.
Name Primary Function
F I Increases the Floor speed.
LOOR NC
F Momentary button that reverses the floor direction. Reverse floor speed can
LOOR
R be modified using the F
EVERSE
while pressing the F
R button, the floor turns off.
EVERSE
T B D Momentary button for lowering the bed.
ILT ED OWN
T B U Momentary button for raising the bed.
ILT ED P
P 1 Three separate preset values may be stored for both floor and option speeds.
RESET
P 2
RESET
P 3
RESET
S Used in conjunction with the P
TORE
memory.
O S Provides functional control of the rear option including on/off and displaying
PTION TART
the option speed.
O S Stops the option.
PTION TOP
O D Decreases the option speed.
PTION EC
O I Increases the option speed.
PTION NC
A S Stops both floor and option.
LL TOP
31
I and F
LOOR NCREASE
R button. Upon release of the F
LOOR EVERSE
button to store or establish a preset
RESET
Key Functionality Elements
•
When you turn on the handheld remote, the
display should read FLR OFF and OPT OFF in
approximately 5 seconds. If the words "waiting
for base" are in the display, ensure that there
is electrical power to the base unit and that the
E-S button on the base unit is pulled out.
TOP
•
There is always a current working memory.
Current working memory is not a preset. When
you turn on the handheld remote, it uses the last
saved work settings from current working memory.
•
The operational sequence of the handheld remote
start buttons is as follows:
1. Press the start button once (A
F S
LOOR TART
D S
LOOR ECREASE PEED
LOOR
S
LL TART
, or O S ) calls up the
PTION TART
buttons
,