Autohandler Mode (Options Menu); Blank Check Device (Options Menu); Communications (Options Menu) - Xilinx HW-130 User Manual

HW-130 Programmer User Guide

Autohandler Mode (Options Menu)

Use this command to turn the autohandler mode on or off. When you
turn on the autohandler mode, a Handler Mode field is added to the
bottom right-hand side of the display. If you have not installed an
auto-handler, this command should be set to off.
Figure 3-3 Handler Mode Set to On

Blank Check Device (Options Menu)

Use this command to check that the device is blank. This command is
available after you have specified a device type.
Figure 3-4 Blank Check Toolbar Button

Communications (Options Menu)

Use this command to set the port and baud rate of the HW-130
3-4
Handler Mode
Xilinx Development System