Note: The results are only as good as the equipment used to measure
the programmer's results. Ensure that your meters are calibrated and
accurate.
Note: PV
hardware.
5. Click on the Execute button.
Diagnostics
The diagnostics routines consist of software loops that exercise
various functional blocks within the programmer, allowing you to
verify that the blocks are operating properly.
Use the following guidelines to select and run a test:
1. Select Options
2. Select a diagnostic loop to run.
3. Click on the Execute button to start the test.
4. Check the Diagnostics Status box to view the results of the test.
Note: Once you select and execute a diagnostic loop, the test
HW-130 Programmer User Guide
should be ±1%
PV
pp
should be ±10%
I
pp
should be ±1%
PV
sp
should be ±10%
I
sp
and I
may not be available for your version of the
sp
sp
The programmer firmware executes the calibration routines. The
results are displayed in the Auto-Calibration dialog box.
Diagnostics to display the Diagnostics
dialog box.
Diagnostics Procedures
B-3