Starting The Program - Xilinx HW-130 User Manual

HW-130 Programmer User Guide
3. To manually copy the files to your current directory, enter the
No further setup is required for the software.

Starting the Program

After finishing the installation, start the program as follows:
1. Launch the X-based Windows Manager (e.g. OpenLook,
Note: The HW-130 software has a graphical interface and requires an
X-based Windows Manager.
2. Connect the programmer to the serial port of the workstation and
3. Turn on the power switch at the back of the HW-130 Programmer.
4. Change directory to the install_dir (the directory where the
Note: If the software cannot establish communication with the
programmer, a message is displayed and indicates possible reasons
for the communication failure.
1-12
following tar command at the command line:
Sun OS:
tar xvf/cdrom/sn2/hw130
Solaris:
tar xvf/cdrom/sol/hw130
or
Note: Vold (Volume Management Deamon) might
have mounted the CD-ROM to '/cdrom/hw130' or
'/cdrom/cdrom0' in which case you should run
'tar xvf /cdrom/hw130/sol/hw130' or
'tar xvf /cdrom/cdrom0/sol/hw130'
HP:
tar xvf /cdrom/hp7/hw130
IBM:
tar xvf /cdrom/rs6/hw130
OpenWindows or Motif Window Manager) on your system if it is
not already running.
to the power supply of the programmer.
software was installed) and type the following at the command
line:
hw130 &
The HW-130 screen is displayed. It consists of a menu bar and
toolbar buttons. The toolbar buttons allow you to interface
directly with the programmer operations.
Xilinx Development System