Installing Software From Dos; Installing Software - Xilinx HW-130 User Manual

HW-130 Programmer User Guide

Installing Software from DOS

This section covers installation and program start-up from DOS.

Installing Software

To install the software, follow these instructions:
1. Insert the HW-130 Programmer software diskette into the
2. At the DOS prompt, type the following:
3. Follow the instructions on your screen.
Menu Bar
Display
Command Buttons
Status Bar
Selects
Figure 1-7 Main Screen (DOS)
Use the menus and command buttons to interface to the HW-130
Programmer. In general, menu commands are for software
configuration and diagnostics, and command buttons are for
programmer operations. Refer to the online help for a detailed
1-14
appropriate drive and select that drive (typically A:). If you are
using a CD-ROM, insert the CD into the CD-ROM drive (typically
D:).
a:/install.exe↵ (diskette)
d:/dos/install.exe↵ (CD-ROM)
Xilinx
File Options Help
Device Select
Design File
Quantity
:
Pass
:
Fail
:
Device Secured :
Program Device Verify
Load Device Blank
Cancel
Device to be programmed
HW-130 Programmer
XC7372
Algorithm Version
Socket Adapter
1 File Checksum
0 Device Checksum
0
NO
Device Device Checksum
Check Signature String
Exit
Xilinx Development System
:
1.00
HW-133-PC84
:
:
:
Create a File
Append Data
X6034