Options Menu; Help Menu - Xilinx HW-130 User Manual

HW-130 Programmer User Guide
Exit

Options Menu

The Options menu includes commands to execute programmer
commands and commands to configure and diagnose the
programmer. To access this menu with the keyboard on a PC, press
the letter O, underlined in the menu name, while holding down the
Alt key. Press the underlined letter corresponding to the menu option
you want.
Program Device
Verify Device
Load Master
Blank Check Device
Signature String
Device Checksum
Auto-Calibration
Diagnostics
Reset Programmer
Autohandler Mode
Communications
Sound

Help Menu

The Help menu contains commands that enable you to access online
help for the HW-130 Programmer. To access this menu with the
keyboard on a PC, press the letter H, underlined in the menu name,
while holding down the Alt key. Press the underlined letter
corresponding to the menu option you want.
Contents
About HW-130
3-2
Exits the HW-130 software.
Programs the selected device with the
selected design.
Compares the programmed device to the
file currently loaded in the programmer
memory.
Loads the contents of a programmed
device into the programmer memory.
Checks that the device is blank.
Retrieves the signature of devices.
Checks the device checksum.
Measures the voltage and current for
each power supply.
Provides several diagnostics loops to
check the port, memory, pin drivers,
and supply voltage.
Resets the programmer.
Turns the autohandler mode on or off.
Sets the port and baud rate of the
HW-130 Programmer.
Sets the sound on or off.
Lists online help topics.
Displays the program version.
Xilinx Development System