Appendix C Automation; Selecting The Autohandler Mode - Xilinx HW-130 User Manual

Automation
This chapter describes the setup and operation of the HW-130
programmer in conjunction with autohandling equipment.

Selecting the Autohandler Mode

To select the autohandler mode of operation, follow these
instructions.
1. Connect the HW-130 programmer to the autohandler.
PASS SIGNAL
FAIL SIGNAL
Figure C-1 Handler Timing for HW-130 Programmer
HW-130 Programmer User Guide
Refer to Figure C-1 for the appropriate interface timing and Figure
C-2 for signal locations.
+5
START
OF TEST
0
+5
0
Handler Binning Occurs
(Pass)
+5
0
Handler Binning Occurs
Request assistance from the autohandler manufacturer for proper
connection (both mechanical as well as electrical).
Appendix C
Start Pulse
20 ms (typ)
X6616
(Fail)
C-1