Specifying A Profile; Creating A Profile - Xilinx HW-130 User Manual

Note: If an XC1700 design does not fit the targeted device, a message
is displayed, informing you that your design file is too large for the
selected device. In this case, you must select a larger device to fit your
design.
Specifying a Profile
Use the Profile command to define information for a programming
session and save it to a file. You can store setup information for a
selected device, such as a specific design file, secure option, or the
Reset Polarity. When you select a profile, it automatically sets up the
programmer to the desired conditions, with no intervention on your
part. Profile is accessible at any time during a programming session
from the File menu or from the toolbar, enabling you to load a preset
profile.
Figure 2-7 Load Profile Toolbar Button
Creating a Profile
To create a profile, follow these instructions:
1. Select Profile
2. Select a device from the Device List.
3. Select Secure Device(s) or Reset Polarity Active High,
4. Click on OK.
5. Select a design file from the Open File dialog box.
6. Click on OK after choosing the correct file.
7. A dialog box appears, displaying the items that you selected to
HW-130 Programmer User Guide
The design file that you specify is downloaded to the memory of
the HW-130 Programmer when you click on the Design File OK
button. The File Checksum field is updated with the checksum of
the downloaded file.
Create from the File menu.
or Reset Polarity Active Low, depending on the device
selected.
Programmer Operations
2-5