Appendix B Diagnostics Procedures; Auto-Calibration - Xilinx HW-130 User Manual

Diagnostics Procedures
This appendix explains how to monitor the calibration of the HW-130
Programmer and how to run the diagnostic tests.

Auto-Calibration

The HW-130 Programmer automatically calibrates itself whenever
you turn on the power or you use the Reset Programmer command.
However, the HW-130 provides the capability to monitor the
operation of the calibration circuitry. The calibration adapter shown
in the following figure is required.
Figure B-1 Calibration Adapter
HW-130 Programmer User Guide
R
1 2 3 4
HW-130-CAL
+ +
I I
pp cc
PVpp PVcc PVsp
Appendix B
CLOSED
OPEN
+
I
sp
X4922
B-1