Avaya J129 Installing And Administering page 98

Appendix
Parameter name
RECOVERYREGISTERWAIT
REDIRECT_TONE
REGISTERWAIT
REUSETIME
November 2017 Installing and Administering Avaya J129 IP Phone in third-party call control setup
Default value Description
• 5: The tone volume is 25dB below the transmit
audio level.
• 6: The tone volume is 20dB below the transmit
audio level.
• 7: The tone volume is 15dB below the transmit
audio level.
• 8: The tone volume is 10dB below the transmit
audio level.
• 9: The tone volume is 5dB below the transmit
audio level.
• 10: The tone volume is equal to the transmit
audio level.
60 Specifies a number of seconds. If no response is
received to a REGISTER request within the
number of seconds specified by
WAIT_FOR_REGISTRATION_TIMER, the phone
will try again after a randomly selected delay of
50% to 90% of the value of
RECOVERYREGISTERWAIT.
Valid values are 10 through 36000.
1 Specifies the tone to play when a call goes to
coverage.
Valid values are 1-4.
900 Specifies the number of seconds between re-
registrations with the current server.
60 Specifies the number of seconds that the DHCP is
attempted:
• With a VLAN ID of zero. True when L2Q is set to
1.
• Or with untagged frames. True if L2Q is set to 0
or 2.
• And before reusing the IP address and the
associated address information, that the phone
had the last time it successfully registered with a
call server.
While reusing an address, DHCP enters the
extended rebinding state described above for
DHCPSTD.
Valid values are 0 and 20 through 999. The default
value is 60. A value of zero means that DHCP will
try forever and there will be no reuse.
Comments on this document? infodev@avaya.com
Table continues...
98