Avaya J129 Installing And Administering page 79

Parameter name
ENABLE_REDIAL
ENABLE_REDIAL_LIST
ENABLE_SHOW_EMERG_SK
ENABLE_SHOW_EMERG_SK_U
NREG
ENABLE_STRICT_USER_VALID
ATION
November 2017 Installing and Administering Avaya J129 IP Phone in third-party call control setup
Default value Description
Specifies if Redial softkey is available.
Value Operation
• 0: No
• 1: Yes
Specifies if the phone redials last number or
displays list of recently dialed numbers.
Value Operation
• 0: Last number redial
• 1: Select the last number redial or from the redial
list.
2 Specifies if Emergency softkey, with or without a
confirmation screen, is displayed when the phone
is registered. All emergency numbers are always
supported.
Value Operation
• 0: Emergency softkey is not displayed.
• 1: Emergency softkey is displayed without a
confirmation screen.
• 2: Emergency softkey is displayed with a
confirmation screen.
2 Specifies if an Emergency softkey, with or without
a confirmation screen, is displayed when the phone
is not registered.
All emergency numbers will always be supported.
Value Operation
• 0: Emergency softkey is not displayed.
• 1: Emergency softkey is displayed without a
confirmation screen.
• 2: Emergency softkey is displayed with a
confirmation screen.
0 Specifies that the validation is done for the To
header and Request-URI against AOR and
Contact header during phone registration.
Value Operation
• 0: No validation.
• 1: Validates the phone registration.
Comments on this document? infodev@avaya.com
List of configuration parameters
Table continues...
79