Vlan Parameters - Avaya J129 Installing And Administering

VLAN parameters

The following configuration parameters are used to configure VLAN functionality on the network
switch internal to the phone.
Parameter name
L2Q
VLANTEST
November 2017 Installing and Administering Avaya J129 IP Phone in third-party call control setup
Default value
0
60
Comments on this document? infodev@avaya.com
Virtual LAN (VLAN) overview
Description
Specifies the VLAN tagging is
enabled or disabled.
Value operation:
• 0: Auto. VLAN tagging is turned
on when the network can
support VLAN tagging and
L2QVLAN is non zero.
• 1: On. VLAN tagging is turned
on when the network can
support VLAN tagging. The IP
phone sends tagged frames with
VLAN = L2QVLAN, even if
L2QVLAN is set to 0.
• 2: Off. VLAN functionality is
disabled.
L2Q is configured through:
• Local admin procedure
• A name equal to value pair in
DHCPACK message
• SET command in a settings file
• DHCP option 43
• LLDP
Specifies the number of seconds
that the phone waits prior to failing
back to a different VLAN ID if no
response is received from the
DHCP server.
Valid values are 0 through 999.
Value operation:
• 0: The phone continues to
attempt a DHCP REQUEST
forever.
VLANTEST is configured through:
• Settings file
Table continues...
23