Avaya J129 Installing And Administering page 97

Parameter name
R
RDS_INITIAL_RETRY_ATTEMPT
S
RDS_INITIAL_RETRY_TIME
RDS_MAX_RETRY_TIME
RECORDINGTONE
RECORDINGTONE_INTERVAL
RECORDINGTONE_VOLUME
November 2017 Installing and Administering Avaya J129 IP Phone in third-party call control setup
Default value Description
6: Packet loss is > 1% or round trip network delay
is > 400ms or jitter compensation delay is > 80ms
15 Specifies the number of retries after which the
phone abandons its attempt to contact the PPM
server.
Valid values are 1 through 30.
2 Specifies the number of seconds that the phone
waits for the first time before trying to contact the
PPM server again after a failed attempt. Each
subsequent retry is delayed by double the previous
delay.
Valid values are 2 through 60.
600 Specifies the maximum delay interval in seconds
after which the phone abandons its attempt to
contact the PPM server.
Valid values are 2 through 3600.
0 Specifies whether call recording tone is generated
on active calls.
Value Operation
• 0: Call recording tone is not generated (default).
• 1: Call recording tone is not generated.
15 Specifies the number of seconds between call
recording tones.
Valid values are 1 through 60.
0 Specifies the volume of the call recording tone in
5dB steps.
Value Operation
• 0: The tone volume is equal to the transmit audio
level (default).
• 1: The tone volume is 45dB below the transmit
audio level.
• 2: The tone volume is 40dB below the transmit
audio level.
• 3: The tone volume is 35dB below the transmit
audio level.
• 4: The tone volume is 30dB below the transmit
audio level.
Comments on this document? infodev@avaya.com
List of configuration parameters
Table continues...
97